Well, I redid the bottome back wall. I found some rot in the one corner. So started work on it.
I had a real issue from the outside to get it to all line up, there had been an issue by the looks of it at the factory. So the driver side lower was really bent over to line up. This seamed to be due to the right hand side of the lower back being cut to short to fit.
I replaced some more floor, including the floor area for the gas tank. The roof was finished and the door step redone.
Next is to finish the insulation and interior panels. The hard work is behind me, as all the rust and rot are now fixed.
No comments:
Post a Comment